CNC Repair Tip #13: ATC Recovery M-Codes for Mori Seiki MV-35 through MV-55 with Yasnac Control MX-2
In the event of an ATC stoppage on a Mori Seiki MV-35-55 (with Yasnac MX-2 control) you must reset the ATC through the use of the M-codes listed in the table below…
CNC Repair Tip #12: Using Fanuc Parameter RMV
When performing CNC service, you may find it useful to detach an axis that has disconnect alarms due to some other work that you are doing at the time…
…So as long as RMBx is set to (1), the RMV parameter can be used to disregard and axis. In the case mentioned above, we used it to ignore the Y axis alarms and allow the Z axis to be moved with the motor while the scaping work continued.
keep looking »